Heatit floor sensor 3M NTC

SKU: 5430109
Brand:
Unit: pcs
Qty: Tellimisel
Price:
9,00 €
Qty.: - +
   - or -   
Heatit Extra floor sensor for Z-Water or Heatit thermostat.
Floor sensor, Ø4mm  3 meters  NTC 10 kΩ,
Similar products
External room sensor, glass front NTC 10 k?
SKU: 5430108 ,   Qty: 7
25,20 €
The module can be power supplied from a 230V AC mains connection, and is able to deliver an output supply of 24V DC. Heatit Z-Water relay outputs are able to be freely controlled from the Z-Wave network, and can be used for several purposes, e.g. on/off c
SKU: 4512475 ,   Qty: 2
249,90 €
Product information "MCO Home - External Sensor for MCOEMH7H-EH2"
The external Sensor for the electrical floor heating thermostats from MCO needs to be directly connected to the thermostat. The sensor is only used for overheating protection purpose.

For the overheating protection the sensor is located near the floor to overwatch the temperature of the floor. The temperature data of the external sensor will not be shown on the display nor transmitted over Z-Wave. The valuesof the external sensor are only used for internal process of the overheat protection function.
SKU: MCO_900090 ,   Qty: Tellimisel
6,99 €
The MCOEMH8-FC4 thermostat is a device for room temperature control, equipped with Z-Wave wireless technology. It is destined for central control of a 4-pipe fan coil, which influences room climate by heating, cooling, humidify and dehumidify. The device can read room temperature and local time, and automatically control fan speed based on the temperature difference.

The wall thermostat MCOEMH8-FC4 requires a static installation with mains power. Thanks to its modern design with capacitive glass touch panel it is particularly suited for visible installation in living areas.

With the modern designed glass touch thermostats by MCO you can control various heating and cooling systems – e.g. heating cable, heating film, water valve, electrical valve, boiler, fan coil, solar energy controller, heat pump, ventilation system etc,
SKU: MCOEMH8-FC4 ,   Qty: Tellimisel
149,99 €
Heatit Z-TRM2fx is an electronic thermostat for electrical floor heating. The thermostat has a built-in Z-Wave chip that can be connected with Home Automation systems like Fibaro, Futurehome, Smarthings, Homeseer, Vera, Zipato etc.

Heatit Z-TRM2fx is equipped with a single pole switch and it fits most System 55 frames (Elko RS16, Schneider Exxact, Gira, Jung etc.). The thermostat can withstand a load of max 13A /2900W at 230V. At higher loads the thermostat must control a contactor. The thermostat may be connected to two wired external sensors.

The thermostat has the capacity of up to 5 associations (relays, wall plugs etc.).
SKU: 5430560 ,   Qty: 12
139,00 €